Measuring & Marking

Sliding Bevel

A transferable angle. Set it from an existing corner or a drawing, then carry that angle to the saw.

Measure stage

Specification

Blade	180 mm hardened steel
Stock	Rosewood with brass lock
Lock	Cam lever, brass
Accuracy	±0.5° at 100 mm
Finish	Oiled, non-reflective
Weight	205 g

What it is for

A transferable angle. Set it from an existing corner or a drawing, then carry that angle to the saw. This guide covers what the tool does, the specification points that actually change your results, and how to use it without damaging the work or yourself.

Where it fits in the build

This is a measure stage tool in the Measuring & Marking category. Lay out accurate parts before any cut is made.

Measure Measuring & Marking

Using it well

Tighten the lever firmly — a slipping bevel is worse than no bevel.
Set it against the actual surface you are matching rather than reading degrees off a protractor when possible.
Check the blade is flush with the stock edge before trusting an angle.

Compatible materials

Materials this tool handles without compromise. Where a material is not listed, check that the tool is rated for it before committing to a cut.

Hardwood
Softwood
Plywood

Reference sample in 3D

The model above is a real walnut reference block rendered in the browser. It is simulated from a height field rather than photographed, so you can rotate it to see how light behaves across the grain, the end grain and the edges. Drag it, or use the view buttons to look at the top face or the end grain in isolation.

Why this matters

Reading how light falls across a board is the fastest way to judge whether a surface is flat. That is the same judgement you make with a hand plane or a sander, and it is much easier to see on a rotating model than on a static photo.

Educational content only. Settings, capacities and safety guidance here are general starting points, not instructions for your specific tool, material or situation. Always follow your tool manufacturer's manual and any material datasheet, and check your own measurements before cutting.

Tools that work alongside this one

All tools

Tape Measure

The first tool you reach for on any project. A 5 m locking tape with a true-zero hook covers nearly all furnitur…

Measuring Measure →

Combination Square

A square, a straightedge, a depth gauge and a level in one. Accurate 90° and 45° references set the standard for…

Measuring Measure →

Marking Gauge

The tool that puts a knife line exactly parallel to a face. Better than a pencil for joinery because the knife s…

Measuring Measure →

Hand Saw

Quiet, accurate and cheap to run. A 22 in crosscut saw still finishes most furniture joints better than a power …

Cutting Cut →